i often run into the problem of when using /h all that it highlights blocks that were edited before a reset. I was wondering if it was possible to make it such that highlight would only select the blocks that were edited after the reset. I kind of doubt it because of the block changes thing but you never know.

_________________

Nope. Since a map restore is not stored, it's very difficult to determine when it was restored. If you want to limit highlight, use a different time value. 3,600 is 1 hour, 5,400 is 90 minutes, 86,400 is 24 hours, etc, is the best way around this issue.

why didn't i think of that :O

_________________